LilyGO TTGO T3 LoRa32 433MHz V1.6.1 ESP32 OLED

LilyGO TTGO T3 LoRa32 433MHz V1.6.1 ESP32 with OLED

​The TTGO LoRa32 from LilyGO is a microcontroller based on an ESP32 with a built-in LoRa chip and an OLED display. The USB to serial converter makes it easy to program, even as an Arduino. The board has a micro USB connection with which it can be programmed and/or powered (micro USB cable not included).

See more on https://github.com/Xinyuan-LilyGO/TTGO-LoRa-Series

• Hardware interface(s):
  • I2C
  • I2S
  • SPI
  • UART
  • PWM
  • ADC
  • DAC
  • GPIO
  • USB CDC
• Number of IO-pins: 19
• Maximum available hardware PWM channels: 8
• Maximum available analog input pins (ADC): 13
• Maximum available analog output pins (DAC): 2
• Maximum available hardware UART interfaces: 3
• Maximum available hardware I2C interfaces: 2
• Maximum available hardware SPI interfaces: 2
• USB to serial converter: CH9102F
• Supported SD card size: Micro SD

• Interface(s):  Wi-Fi, Bluetooth, LoRa
• Wi-Fi chip/SoC:  ESP32
• Wi-Fi frequency [GHz]:  2.4
• Bluetooth chip/SoC:  ESP32
• Bluetooth version: 4.2
• Supported Bluetooth standard(s): LE Classic
• LoRa chip/SoC:  SX1278
• LoRa frequency [MHz]:  433

• Type: OLED
• Driver: SSD1306
• Screen diagonal [inch]: 0.96
• Number of pixels long side: 128
• Number of pixels short side: 64
• Pixel colors: White

• Power supply connector(s): Through hole solder pin(s) (2.54mm), Micro USB female
• IO-connector(s): Through hole solder pin(s) (2.54mm), Micro USB female
• Battery connector(s): Molex Picoblade (compatible) male
• Pin distance [mm]: 2.54
• Wi-Fi/Bluetooth antenna connector: Built-in antenna
• LoRa antenna connector: SMA female, IPEX MHF 1/uFL male (requires modification)

• 1x TTGO T3 LoRa32 433MHz
• 1x LoRa antenna
• 1x Battery cable
• 1x Male pin header set

Write a review