Your shopping cart is empty!
Categories
- 3D Printing and Plastic peripherals (6)
- 433Mhz and Lora (9)
-
Amateur Radio (499)
- - Antenna Analyzer (10)
- - APRS (4)
- - ATU (3)
- - Digital Modes (4)
- - DMR (4)
- - Echolink (1)
- - Enclosure (10)
- - Eshail-2 (QO-100) (64)
- - GPS (4)
- - iGate (1)
- - Microcontrollers (35)
- - Microphone (1)
- - Programming Cable (5)
- - QRP (6)
- - Radio interface (15)
- - Repeater (3)
- - RF Amplifiers (14)
- - RF Kits (17)
- - RF modules (102)
- - SDR (60)
- - Spectrum Analyzer (2)
- - SWR (8)
- - Transceiver (42)
- - WSPR (4)
- Antennas and Acc (230)
- Audio and Video (24)
- Bluetooth (9)
- Cables (23)
- Computer Peripherals (90)
- Connectors (77)
- Data acquisition (1)
- Enclosure (9)
- GPS (4)
- Hardware (1)
- Home Automation (89)
- Inverter (9)
- Lora (6)
- Microcontrollers (97)
- Modbus (3)
- MQTT (14)
- Network Radio (3)
- Networking (8)
- Power (101)
- Power supply (44)
- RF Modules (129)
- ROIP (2)
- Satellite (68)
- Security (8)
- Sensor (15)
- Solar (14)
- Test and Measurements (36)
- Tools and Equipment (7)
- VOIP (9)
- Weather (1)
LILYGO TTGO T-Beam ESP32 433Mhz V1.1 WiFi Wireless bluetooth Module GPS NEO-6M SMA LORA32 18650 Battery Holder
Price: R805.00
Ex Tax: R805.00
Ex Tax: R805.00
Qty:
- OR -
Add to Wish List
Add to Compare
Add to Compare
LILYGO TTGO T-Beam ESP32 433Mhz V1.1 WiFi Wireless bluetooth Module GPS NEO-6M SMA LORA32 18650 Battery Holder
Feature:
| Working voltage | 1.8~3.7V |
| Acceptable current | 10~14mA |
| Transmit current | 120mA@+20dBm |
| 90mA@+17dBm | |
| 29mA@+13dBm | |
| Operating frequency | 433Mhz |
| Transmit power | +20dBm |
| Receive sensitivity | -139dBm@LoRa &62.5Khz&SF=12&146bps |
| -136dBm@LoRa &125Khz&SF=12&293bps | |
| -118dBm@LoRa &125Khz&SF=6&9380bps | |
| -123dBm@FSK&5Khz&1.2Kbps | |
| Frequency error | +/-15KHz |
| FIFO space | 64Byte |
| Data rate | 1.2K~300Kbps@FSK |
| 0.018K~37.5Kbps@LoRa | |
| Modulation Mode | FSK, GFSK, MSK, GMSK, LoRa TM, OOK |
| Interface form | SPI |
| Sleep current | 0.2uA@SLEEP |
| 1.5uA@IDLE | |
| Operating temperature | -40℃ ~ +85℃ |
If you need additional OLED, you can buy it from us
Product Upgrade Content:
1. Pin GPIO34 pin is replaced with GPIO35
2. Replace the charging IC (TP5400) with the power management AXP192
3. GPS TX, RX pin replacement
4. Power on and remove, replace with button to open
5. Reduced sleep current
6. GPS battery replacement
OLED Description: (OLEF is not included)
ESP32 Features:
- Lastest ESP32 Version: REV1
- WIFI
- bluetooth
- 4MB PSRAM
- 4MB Flash
- 3D Antenna
LORA Features:
- Working voltage: 1.8~3.7v
- Acceptable current: 10~14mA
- Transmit current: 120mA@+20dBm, 90mA@+17dBm, 29mA@+13dBm
- Operating frequency: 433/470MHz(433HMz version)
- Transmit power: +20dBm
- Receive sensitivity:
- -139dBm@LoRa &62.5Khz&SF=12&146bps
- -136dBm@LoRa &125Khz&SF=12&293bps
- -118dBm@LoRa &125Khz&SF=6&9380bps
- -123dBm@FSK&5Khz&1.2Kbps
- Frequency error: +/-15KHz
- FIFO space: 64Byte
- Data rate: 1.2K~300Kbps@FSK, 0.018K~37.5Kbps@LoRa
- Modulation Mode: FSK,GFSK,MSK,GMSK,LoRa TM, OOK
- Interface form: SPI
- Sleep current: 0.2uA@SLEEP, 1.5uA@IDLE
- Operating temperature: -40℃- +85℃
- Digital RSSI function
- Automatic frequency correction
- Automatic gain control
- Low voltage detection
- Fast wake-up and frequency hopping
- Highly configurable data packet handler
- Radio Semtech SX1276
GPS:
- GPS modules NEO-6M, 3V-5V power supply Universal
- Destined module with ceramic antenna, signal super
- Save the configuration parameter data EEPROM Down
- With data backup battery
- There are LED signal indicator
- Default Baud Rate: 9600
Power:
- TP5400
- 1A Battery Management
- LED indicator: There are 4 LEDs show the battery status in real time.
- USB: CP2104-GMR
- Pre-Flash Firmware: -SoftRF V4.0
Package includes:
1 x 0.96 inch 128X64 OLED This module is not included but can be purchased separately.
1 x TTGO T-Beam ESP32
1 x Antenna
2 x Pin strips
Defult Software:
Default admin software installed is https://github.com/lyusupov/SoftRF
Connect to WIFI SoftRF-[Last 6 digits of Mac address]
PW: 12345678
GPS is lock if led at UPS block is flasing (nect to Antenna connector
Conect to admin screen http://192.168.1.1
Serial Port ?? Board 38400
This Unit can be configured as a Lora APRS tracker using the folowing software.
https://github.com/antonjan/LoRa_APRS_Tracker
More information:
Default software installed is http://github.com/lyusupov/SoftRF
https://github.com/geeksville/Meshtastic-Android/blob/master/README.md
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
Powered By OpenCart
Giga Technology © 2022
Giga Technology © 2022